DURABLE SOLID WOOD - Tchosuz Wooden Furniture Legs are made of eco-friendly rubberwood and well finished with 2 layer white coating. Solid wood material makes the product can support more than 250lbs. With its humidity <12%, no beetle, no musty, ensure the safety to use at home. DIY FURNITURE REPLACEMENT - Raise the height of low furniture by replacing our modern furniture legs, make you easy to clean the place under the furniture; Or upgrade your furniture and your home's style to a modern look in minutes, giving your furniture a restyling has never been easy or more affordable! SUCH EASY INSTALLATION - There is a full hardware kit contains 4 furniture legs with pre-installed 5/16" hanger bolt, 4 insert nuts, and enough screws, you only need a screwdriver to install these replacement legs within 3 mins. Each wood leg also comes with a rubber protector! Use them to protect the floor from damage to the feet, or as an additional stabilizer for your tables or chairs. 5/16" HANGER BOLTS - Tchosuz replacement feet are pre-drilled 5/16 inch threaded bolts, which will fit most furniture. Please kindly pay attention, if our furniture legs do not fit into your old furniture attached with different bolts, please don’t worry, you can use our Insert Nuts to screw in the legs. MEET EVERY DEMAND - Match other kinds of hardwoods to ensure compatibility with a wide variety of furniture like couches, sofas, chairs ottomans, and so on. Feature
-Get the new look of wood legs with improved stability and strength.
-Attachment T-Nuts and screws make this leg fast and simple to install on any piece of furniture.
-Padded legs protector to protect your floor from scratches and scuffs.
-Designed for sofas, upholstered chair, couch, bench, cabinet, coffee table, TV stand, bed, office furniture, kitchen, shelves, side table, and dresser in modern, minimalist and contemporary styles.


Specification
-Condition: 100% New;
-Material: Rubber Wood;
-Upper Diameter: 3inch / 7cm;
-Bottom Diameter: 2inch / 5cm;
-Bolt Thread: 5/16 inch;


Easy to install
-1.Position the T-nuts near the furniture’s corners.
-2.Drill 4 holes through the base if there is no existing ones.
-3.Tap the T-nuts into the holes with a hammer.
-4.Twist the legs onto the T-nuts until they are even with the furniture.


Note
-Due to the effect of light and monitor, the color may be slightly different from the actual product.
-Please allow 1-2mm error due to manual measurement.


What’s Included
-4x Wood Legs
-4x T-Nuts
-4x Gummi Pads
-1 Set of Screws